Program directv rc64r remote

If the device is not responding check the batteries in the remote it may be that batteries are exhausted. Use the remote control's mode buttons to set the remote to the correct mode for the equipment. Be sure to program the remote control to operate the other equipment as described on manual.

To change the mode, press the button for the equipment you want to control. The mode button lights for three seconds to show you've set the remote to that mode. Depending on how the remote is set up, the remote control may use UHF radio signals, IR signals, or both to control the receiver.

However, only IR signals are used to control other equipment. IR signals travel short distances generally 20 feet or 7 meters they can go up to 40 feet, and cannot go through walls or other solid objects.

Point the remote control directly at the equipment you want to control, with no objects to block the signal path. The process may take up to 30 minutes. Step 1: Turn on your device. Insert a tape or disk if applicable. Step 5: Press "PWR" or other functions e. Step 6: Point the remote at the TV or component and repeatedly press "Channel Up" until your device turns off or performs the action you selected in step 5.

If you accidentally pressed "Channel Up" after your device responded press "Channel Down" to step back a code. Note: If the light flashes 3 times, you've cycled through all codes and the code for your device was not found. You must use the remote that came with your device.

Once you have set up the DirecTV Universal Remote Control using Code Search , perform the following procedure to find out the 5-digit code to which your component responded:. Step 1: Slide the mode switch to the appropriate position. Step 3: Enter 9 9 0. The green light under the selected switch position will flash twice. Step 4: To view the first digit in the code, press and release the number "1" key.

Wait 3 seconds, and count the number of times the green light flashes. Also, try turning down the brightness on your TV. First, which remote do you have? Find them by using this code lookup tool. Follow the on-screen prompts to complete the process. Slide the mode switch located at the top of the remote to TV. Hold down the Mute and Select buttons at the same time.

Let go when the green light flashes twice. Enter The green light should flash twice again. While you continue to aim the remote at your device, hold down the Mute and Enter buttons. Press Menu on the remote. Follow the on-screen instructions to complete the pairing process. Use the instructions below for manual pairing. While aiming the remote at your device, hold down the Mute and Select buttons.

Press the Channel Up button.